How can you focus sound?

Question

I saw this TED talk and I am curious as to how the sound is focused on the general level. Can anyone explain this or does anyone have any good articles?

Answer 1

I don't think anyone here has really answered your question. In this case, the sound is "focused" using phased arrays. The face of the audio spotlight has multiple transducers:

Flickr

The same signal is output from each of them, but delayed slightly by different amounts, so that the wavefronts all reach the same point in front of the device at the same time. This "virtual focus" is called beamforming.

ref ref

This is how modern radars focus their beams, too. Instead of spinning a satellite dish around, they have lots of little elements that don't move, but the signals are delayed to produce different beam shapes.

Answer 2

Sound is a type of wave, so it has all the wave properties similar to other waves such as light waves. For light waves, you can use a lens to focus the light. A lens has higher refractive index, or lower light speed than the environment. The same is true for sound wave, so what you need is to make a high refractive region [1].

The air surrounding us can be approximated by the ideal gas, so the speed of sound is [2]

$c=\sqrt{\gamma\frac{P}{\rho}}$

where $\gamma$ is the adiabatic index, $p$ is pressure of the air, $\rho$ is density of the air

Here, we want to create a region with high refractive, or equivalently low sound speed. There are few way to achieve this, one is to decrease the pressure, another way is to decrease the temperature (by the ideal gas law $PV=NRT$). However, in both cases, you either need a hard container or a refrigerator near it to keep it cold.

On the other hand, increasing the density can be easily done by using a heavy gas such as carbon dioxide. You just need to fill the gas in a balloon and it can act as a very simple acoustic lens. Note that the size of the balloon or other container must be large compared with the wavelength. There are also other methods to focus sound without using lens. [3]

As said before, the same mechanism can be applied for other wave, for example, a water wave. In a shallow water tank, adding a lens shape obstacle at the bottom can converge water wave because water wave move slowly at the shallow region. This experiment can be easily performed in one's home.

[1] http://hyperphysics.phy-astr.gsu.edu/hbase/sound/refrac.html

[2] http://en.wikipedia.org/wiki/Speed_of_sound#Speed_in_ideal_gases_and_in_air

[3] http://focus.aps.org/story/v14/st3

Answer 3

These ‘audio spotlights’ work by emitting ultrasound at two different frequencies; it is the short wavelength of the ultrasound that causes the beam to be so directed. The two waves interfere and produce sum and different tones at frequencies of $f_1+f_2$ and $f_1-f_2$; if the ultrasound frequencies are, say, $f_1=45\,$kHz and $f_2=44\,$kHz, the difference tone will be at $1$kHz which is in the audible range for humans.

I knew some people who looked at using audio spotlights for noise control some time ago, but (IIRC) the general consensus is that since you're subjecting your victims with very large amounts of ultrasonic noise (greater than 100dB), these devices are probably not too safe for continuous use. (Or, at least, their safety was in no way assured.)

Answer 4

On the general level, you focus sound the same way you focus light -- either by reflecting it from a parabolic surface, or letting it pass through an acoustic lens. An acoustic lens is just like an optical lens in that it consists of a material with a different propagation speed of sound, with varying thickness. See the Wikipedia article on acoustic mirrors.

Answer 5

Sound is a wave just like light is a wave. You can use a parabolic shape reflector with a speaker at the vocal point to transmit sound in a "pencil beam".