1

As I have to design the vertebra bone and its natural boundary conditions I came across a problem.

How can I applied a uniform load if the place where the force is applied is a parabolic curve.

Ok so I get the curve will have this value $$y(x) = -y_1/x_1 \cdot x^2 + y_1$$

So I did the derivative $\frac{dy}{dx}$ to discover the tangent of the curve so it can be possible to calculate the normal force so I can apply the normal force to the surface.

My question is how is it applied to the surface?

Stefan Bischof
  • 1,910
  • 1
  • 20
  • 26
Barão António Lopes
  • 11
  • 2
  • Not enough information to answer. Uniform and normal to the curvature of the spine or uniform parallel to the direction of gravity (i.e. the weight of each vertebra) – Mark Rovetta Jun 06 '13 at 18:49
  • Welcome to Physics SE! Your question still is not obvious to me. You used a 2D function to discribe your 3D bone. Are you asking for the normal force, which is applied to a 2D bone? – Stefan Bischof Jun 06 '13 at 18:50
  • I'm using a two dimensional plate and constantly remodelling the bone taking the small values of density till I arrive to the trabecular disposition like in a RX. but now I have to impose the natural boundary conditions and I have some difficulty cuz I don't know how to applied this force. the force is uniform they all have q0 value and they follow the curve (uniform and normal to the curvature of the spine) – Barão António Lopes Jun 06 '13 at 19:08
  • this picture illustrates the force and how it has to be applied imageshack – Barão António Lopes Jun 06 '13 at 19:48

0 Answers0